OMEC F9 The multiple milling machine OMEC F9 is used to make parallel indents for door frames and other furniture pieces. The machine is equipped with a cutter unit and two saw units to allow the machining of 45° cut. The F9 model machine automatically single both cases and single crosspieces. The locking of the pieces takes place automatically at the beginning of each cycle. The same takes place for the release of the pieces at the end of each cycle. Controls are located on a built-in control panel. The F9 model is controlled by a numerical control system which is entrusted with the working cycle control.

TECHNICAL CHARACTERISTICS
On board machine installed power	Kw 10,5
Working pressure	Mpascal 0,7
Cutter	n° 1
Cutter revolutions	rpm' 5.600
Blades	n° 2
Blade revolutions	rpm 2.800
Average production of full door frames	nph 30
Machine weight	kg 850
Dimensions of the package	cm 140x180x180

DIMENSIONAL LIMITS OF WORKPIECES
Dimensions	Length	Width	Indent Height	Case Thickness	Crosspiece Thickness
Minimum	500mm	60mm	50mm	15mm	15mm
Maximum	2500mm	300mm	50mm	50mm	50mm

STANDARD COMPOSITION

n.1Ø200x30 mill cutters with HM knives

Series of n°2 Ø250x3,2 blades with HM knives

Tool kit for adjustment and maintenance

Instruction and operator's manual

OPTIONAL (supplied on specific request of Customer
A20	Ø250x3,2 blades with HM knives
A30/01	Ø200x10 mill cutters with HM knives
A30/02	Ø200x20 mill cutters with HM knives
A30/03	Ø200x30 mill cutters with HM knives
A32/02	HM knife for mill cutters mm.10
A32/03	HM knife for mill cutters mm.20
A32/04	HM knife for mill cutters mm.30
A33	Scribing knife for mill cutters

<<back